Gears / Gear Designer
Gear Designer

Involute gears that mesh, by module or diametral pitch

Spur, helical and herringbone gears, generated the way a cutter makes them. Design one gear or a meshing pair, an internal ring or a rack, and download STL, STEP, DXF or SVG.

A meshing herringbone gear pair in 3D: module 2.25, 20 and 30 teeth, on half-inch hex shafts
What it does

Gears done the proper way

Module or diametral pitch

ISO 54 modules and the common diametral pitches; 20° standard, plus 14½°, 25° and stub forms.

Generated teeth

Involute flanks and the true trochoidal root from rolling the rack — undercut shown as cut.

Spur, helical, herringbone

Any helix angle and hand; the pair takes the opposite hand automatically.

Pairs, rings and racks

A meshing pair at the right centre distance, an internal ring gear, or a rack.

Profile shift with limits

Shift each gear, with the undercut and pointed-tooth limits from DIN 3960 shown.

Numbers to check against

Span width over k teeth and dimension over pins — what you measure on the real part.

Backlash the standard way

DIN 3967 tooth thinning series, or your own allowance.

Hubs, bores, spokes

Hubs with set screws or hub pins; D-flat, keyway, ISO 14 and ISO 4156 spline and hex bores with retaining rings, and a sample shaft to match; spokes.

The same files

STEP, STL, DXF, SVG and PNG, with print compensation in the STL only; one STEP holds the whole drive.

Tooth systems

Supported tooth forms

SystemSizesForms
ModuleISO 54 modules20°, 14½°, 25°, 20° stub; ISO 53 racks A to D
Diametral pitchThe common pitches20°, 14½°, 25°, 20° stub, Fellows stub
Samples

Open a ready-made gear set

Robot gearboxes, printed drives, industrial and inch gears, ring gears and racks. Each opens with both parts in mesh, ready to change.

All 25 gear samples →

Questions

Good to know

Which file formats can I download?

STEP (true nominal size, for CAD), STL (with your print compensation, for 3D printing), DXF and SVG (true lines and arcs, for laser cutting and CAD sketches) and PNG, for each gear; for a pair, the STEP holds both gears in mesh.

Will two gears mesh?

Turn on the two-gear drive: gear 2 takes the same module or pitch and the opposite helix hand, and the centre distance follows from the two profile shifts. The check warns about undercut, pointed teeth and contact ratio, and Auto-fix clears what it can.

How do I check a gear I've made?

Each gear's Dimensions show the span width over k teeth and the dimension over pins, with their limits for the backlash allowance you chose: measure the part and compare.

Is designing free?

Yes. Designing and checking are free; downloads cost a few tokens, the same as for pulleys and sprockets, and one purchase covers every file of that design, and you can download them again at no charge later. See Pricing.

Open the designer and make your gear

Opening the tool…
The first load can take a few seconds.