Starter · 3/8 in rod, steel BBs
bore Ø9.53 · OD Ø24.23 · width 7.14 mm · 6 steel BBs Ø4.5
The tested print: a deep groove bearing for a 3/8 in rod, 4.5 mm steel BBs in a crown cage.

The outer race is its own pillow block, raised: its centre height set to 20 mm above the base, well above the 11.35 mm minimum (the base just touching the race). Any centre height from the minimum up can be set. A bulged top and two hold-down feet for M3 screws.
Using the CheapCADTools connector, design a deep groove ball bearing in Printed Bearing Designer, "8 mm shaft · raised pillow block": bore Ø8 · OD Ø22.7 · width 7.14 mm · 5 steel BBs Ø4.5 · pillow block, centre 20 mm above the base (raised from the 11.35 mm minimum). Check the design, apply any Auto-fix it suggests, then export the printed parts as STL and STEP and give me the download link.
Paste it into Claude, ChatGPT or any AI app with the CheapCADTools connector, and it designs this bearing with you, checks it and hands you the files. How to connect your AI.
The link opens the bearing in the Printed Bearing Designer's 3D view. Change the bore, the balls or needles, the outside, then download STL or STEP. Print the fit coupon first, so it fits your printer.
bore Ø9.53 · OD Ø24.23 · width 7.14 mm · 6 steel BBs Ø4.5
The tested print: a deep groove bearing for a 3/8 in rod, 4.5 mm steel BBs in a crown cage.
bore Ø8 · OD Ø22.7 · width 7.14 mm · 5 steel BBs Ø4.5
A 608-sized job for an 8 mm shaft, 4.5 mm steel BBs.
bore Ø10 · OD Ø27.7 · width 8.64 mm · 5 airsoft BBs Ø6
Plastic airsoft BBs as the balls: quiet and cheap, for light loads.
bore Ø12 · OD Ø26.7 · width 12.64 mm · 14 steel BBs Ø4.5 in two rows
Two rows of steel BBs for more load and less tilt.